Smart Search
Cari koleksi dengan cepat sesuai kebutuhan Anda.Mantle control on the geodynamo is often simulated using numerical dynamos with imposed outer boundary heat flux inferred from lower mantle tomography, assuming that seismic and thermal anomalies in the lowermost mantle are highly correlated. However, non-thermal effects might perturb this idealized linear seismic–thermalmapping. Here we use a probabilistic tomography model to isolate the the…
The linear traveltime interpolation has been a routinemethod to compute first arrivals of seismic waves and trace rays in complex media. The method assumes that traveltimes follow a linear distribution on each boundary of cells. The linearity assumption of traveltimes facilitates the numerical implementation but its violation may result in large computational errors. In this paper, we propose a…
This paper presents efficient numerical schemes for 3-D gravity field inversion. We propose a 2-D multilayer model to approximate a 3-D density distribution, and prove that the solution of the multilayer model will converge to the discretized 3-D solution. Differed from the conventional fast Fourier transform (FFT) based methods in which FFT is applied to the kernel, the proposed approach dire…
The fate of subducted slabs is enigmatic, yet intriguing. We analyse seismic arrivals at ∼20–50 s after the direct P wave in an array in northeast China (NECESSArray) recordings of four deep earthquakes occurring beneath the west-central Pacific subduction zones (from the eastern Indonesia to Tonga region). We employ the array analysing techniques of fourth root vespagram and beam-form…
The measurement of ongoing ice-mass loss and associated melt water contribution to sea-level change from regions such as West Antarctica is dependent on a combination of remote sensing methods. Akey method, the measurement of changes in Earth’s gravity via theGRACE satellite mission, requires a potentially large correction to account for the isostatic response of the solid Earth to ice-load c…
Adaptive optimal experimental design methods use previous data and results to guide the choice and design of future experiments. This paper describes the formulation of an adaptive survey design technique to produce optimal resistivity imaging surveys for time-lapse geoelectrical monitoring experiments. These survey designs are time-dependent and, compared to dipole–dipole or static optimized…
Using empirical matched field processing (MFP), we compare 4 yr of continuous seismic data to a set of 195 master templates from within an active geothermal field and identify over 140 per cent more events than were identified using traditional detection and location techniques alone. In managed underground reservoirs, a substantial fraction of seismic events can be excluded from the official c…
Moment accumulation rate (also referred to as moment deficit rate) is a fundamental quantity for evaluating seismic hazard. The conventional approach for evaluating moment accumulation rate of creeping faults is to invert for the slip distribution from geodetic measurements, although even with perfect data these slip-rate inversions are non-unique. In this study, we show that the slip-rate vers…
We present the results of palaeomagnetic analysis on Late Bronge Age pottery from Santorini carried out in order to estimate the thermal effect of the Minoan eruption on the pre-Minoan habitation level. A total of 170 specimens from 108 ceramic fragments have been studied. The ceramics were collected from the surface of the pre-Minoan palaeosol at six different sites, including also samples fro…
Electromagnetic (EM) imaging methods are useful tools for monitoring subsurface changes in pore-fluid content and the associated changes in electrical permittivity and conductivity. The most common method for georadar tomography uses a high frequency ray-theoretic approximation that is valid when material variations are sufficiently small relative to the wavelength of the propagating wave. Geor…